Plaster and Drywall Repair in Covington, Kentucky
Plaster that is 100 years old can still be saved. We repair cracks and loose sections so the patch sits flat, and we work around the trim you want to keep.

Old plaster is not drywall
Plaster went up in layers over wood lath. The first coat pushed through the gaps between the slats and curled behind them. That curl is what holds the wall. When it breaks, the plaster separates from the lath and the wall goes loose, even if it still looks fine.
Covington was incorporated in 1815, and entire blocks here were built in the 19th century. Seminary Square's National Register listing names Second Empire, Italianate and Federal styles. Houses like that were commonly plastered, so a repair that treats the wall like a modern board will not last.
Signs the plaster needs work
- A crack that follows a window or door corner and opens in cold months.
- A hollow sound when you knock, or a soft give when you press.
- A bulge or bubble, often where paint has been layered on.
- Chunks or sand on the floor under a wall or ceiling.
- Old patches that have fallen out or telegraph a line through the paint.
How we repair it
- Test. We tap the wall to find where plaster is tight and where it has come off the lath. The loose area is usually wider than the crack.
- Secure. Loose sections get fastened back to the lath, or cut out if they will not hold. Edges get cleaned and cut square.
- Fill and bridge. Cracks get opened, filled and bridged with mesh or tape. Holes get filled in thin layers with compound that bonds to plaster.
- Feather and prime. Each coat runs wider than the last so the patch disappears into the wall. Then a primer, ready for your painter.
Trim, moldings and everything we leave alone
Many old rooms have original baseboards, window casings and plaster cornices. They cannot be bought again. We tape, wrap and shield them. If a repair has to touch a molding, we stop and talk to you first. We are not a restoration firm and we do not claim to be one. We patch the wall and leave the woodwork the way we found it.
Blending new patches into old plaster takes a wider feather than on drywall. Old walls wave and dip. We follow the wall instead of forcing it flat, and we say so before we start if the surface will not read perfectly flat under raking light.
What we check before we quote
- Whether the plaster is tight to the lath or has gone loose.
- Whether a crack is old and still, or moving.
- Whether there is a leak or a damp source above or behind.
- How many layers of paint and old patches are on the wall.
- What trim and moldings sit near the work.
Short answers
Can you match old plaster texture?
We match the surface to the wall beside it. Smooth plaster gets a smooth patch. Textured or skim-coated walls get a matching finish where we can. A test patch tells us what the wall will take.
Do cracks in plaster mean the house is failing?
Usually not. Plaster moves with seasons and age. A crack that is getting wider week by week is another story, and we will tell you if it needs someone else to look at it first.
Do you replace plaster with drywall?
Only when a section is too far gone to save. We try to keep the original plaster in place. When we do replace, we tell you where the edge between old and new will land.
Do you do full-room replastering?
No. We repair cracks, holes, loose sections and blends. A full room of new plaster is a different trade.
Before we come
A short list. It saves time.
- Clear the floor and move furniture a few feet from the wall.
- Take pictures of the cracks with a coin or ruler in frame.
- Tell us if the wall has been painted or patched before.
- Tell us if the crack has opened or closed with the seasons.